The readings seem opposite of each other, that when one reads lean, the other reads rich.
I set up the LC1 meter according to the specs sheet, MS seems to run the car well enough, but its not in synch.
Any ideas guys?
Megasquirt MSEXTRA / MS3EFI
Support and discussion forum for Megasquirt 1, 2, 3, Microsquirt/module & DIYPNP
MegaSquirt Forums: MSefi, MSextra, MS Success Stories, MS User Groups, MicroSquirt, MSgpio
Quick links: Manuals : Megasquirt info
: Forum help page : Downloads
LC1 meter and megatune
Moderator: efahl
3 posts
• Page 1 of 1
Re: LC1 meter and megatune
by LT401Vette » Wed Aug 20, 2008 11:37 pm
MS1 or MS2?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
LT401Vette - Super MS/Extra'er
- Posts: 6860
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Charlotte, NC
Re: LC1 meter and megatune
by vinister » Wed Aug 20, 2008 11:48 pm
There are 3 places you have to setup the LC1
- in the LM programmer
- In the configurator for the project you are using
- In the megatune calibration tool in the 'tools' menu (only if you're using MS2)
scirocco ;)
- in the LM programmer
- In the configurator for the project you are using
- In the megatune calibration tool in the 'tools' menu (only if you're using MS2)
scirocco ;)
- vinister
- Experienced MS/Extra'er
- Posts: 158
- Joined: Sat Jul 19, 2008 11:04 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests