LT401Vette wrote:Yep this just got reported today on the gpio site.. That is fixed for the next release.
I get this error ( failed to subscribe to DashComp output CH, 21 times )
here is the log file
LT401Vette wrote:Can you install 1.004 in parallel and try that same project?
I don't have an MShift controller here to actually recreate your exact setup. But I do have CAN controllers setup, even turned on blockingFactor like the MSII base code uses and it seems to be working. I don't quite know why your MShift is getting 1 byte short....
If you edited the MShift ini to check page 1 to 632 bytes instead of 633, I bet it would go right online. But, I don't know what byte might be missing. It might be the last one, if maybe something in the middle.
Do you have a project that speaks to the MShift via serial working?
How about a project that has only the MShift set up as the main controller, but you talk to it through the MSII?
LT401Vette wrote:Ok, I think Lance got this sorted.
It seems the the the MSII code didn't like the last odd sized 57 byte block of data. Lance has updated the MShift code to make it a rounded out 64 and it all seems to work again.
He has posted new MShift code over at:
Users browsing this forum: No registered users and 4 guests