MS3X Card dimensions.

[thomas505]

Hey, i'm currently designing an expansion board to sit where the MS3X card would sit, so I was wondering if anyone knew:

• How wide the MS3X card is (or the mainboard - they should be the exact same width)
• The offset of the DB37 connector, as I want to put a DB37 connector to fit in the premachined slot in the endplate.

Thanks, Thomas.

[SymTech Laboratories]

The MS3X is 4.000" wide, and the distance between the bottom of the primary DB37 connector and the bottom of the MS3X DB37 connector is 1.040".

[thomas505]

I actually need the offset of the connector relative to a side of the card - in essence where to place the DB37 connector in my PCB layout. (as the vertical distance is easy to fix by just mounting in a different slot).

Thanks, Thomas.

[SymTech Laboratories]

I actually need the offset of the connector relative to a side of the card - in essence where to place the DB37 connector in my PCB layout. (as the vertical distance is easy to fix by just mounting in a different slot).

Thanks, Thomas.

It's the same as the v3.0 board, about 1.415".

[thomas505]

Hey, so are you saying the dimension in yellow is 1.415"?



Thanks, Thomas.

[SymTech Laboratories]

Sorry, that comment did deserve clarification. It's 1.415" from the edge of the card to pin one.

[thomas505]

No worries Thanks for the help