- How wide the MS3X card is (or the mainboard - they should be the exact same width)
- The offset of the DB37 connector, as I want to put a DB37 connector to fit in the premachined slot in the endplate.
MS3X Card dimensions.
Moderators: jsmcortina, muythaibxr
MS3X Card dimensions.
Hey, i'm currently designing an expansion board to sit where the MS3X card would sit, so I was wondering if anyone knew:
-
- Super MS/Extra'er
- Posts: 2188
- Joined: Sun Aug 31, 2008 4:02 pm
- Location: South Florida, USA
- Contact:
Re: MS3X Card dimensions.
The MS3X is 4.000" wide, and the distance between the bottom of the primary DB37 connector and the bottom of the MS3X DB37 connector is 1.040".
Re: MS3X Card dimensions.
I actually need the offset of the connector relative to a side of the card - in essence where to place the DB37 connector in my PCB layout. (as the vertical distance is easy to fix by just mounting in a different slot).
Thanks, Thomas.
Thanks, Thomas.
-
- Super MS/Extra'er
- Posts: 2188
- Joined: Sun Aug 31, 2008 4:02 pm
- Location: South Florida, USA
- Contact:
Re: MS3X Card dimensions.
It's the same as the v3.0 board, about 1.415".thomas505 wrote:I actually need the offset of the connector relative to a side of the card - in essence where to place the DB37 connector in my PCB layout. (as the vertical distance is easy to fix by just mounting in a different slot).
Thanks, Thomas.
Re: MS3X Card dimensions.
Hey, so are you saying the dimension in yellow is 1.415"?
Thanks, Thomas.
Thanks, Thomas.
-
- Super MS/Extra'er
- Posts: 2188
- Joined: Sun Aug 31, 2008 4:02 pm
- Location: South Florida, USA
- Contact:
Re: MS3X Card dimensions.
Sorry, that comment did deserve clarification. It's 1.415" from the edge of the card to pin one.
Re: MS3X Card dimensions.
No worries Thanks for the help