1.04 to 1.19 question

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

1.04 to 1.19 question

Postby turbo conversion » Sat Dec 24, 2011 5:26 pm

I would like to try 1.19. Current: MS2 Extra 3.1.1 TS 1.04. I went to your site and downloaded the 1.19 and it created another TS with icon. Do I load my current tune then power off and then bring the controller on line. Thanks, David
turbo conversion
Experienced MS/Extra'er
 
Posts: 357
Joined: Thu Aug 19, 2010 6:22 pm

Re: 1.04 to 1.19 question

Postby kjones6039 » Sat Dec 24, 2011 6:02 pm

turbo conversion wrote:I would like to try 1.19. Current: MS2 Extra 3.1.1 TS 1.04. I went to your site and downloaded the 1.19 and it created another TS with icon. Do I load my current tune then power off and then bring the controller on line. Thanks, David


That will work, but I would create a new project in 1.19 and load my current tune to that project. That way your tune will also be saved if you want to go back to 1.04......

Ken
383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.3.1 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
User avatar
kjones6039
Super MS/Extra'er
 
Posts: 985
Joined: Sat Jul 22, 2006 8:02 pm
Location: Eureka, NV USA

Re: 1.04 to 1.19 question

Postby turbo conversion » Sat Dec 24, 2011 7:45 pm

Thank you Ken, that is what I will do. Also, how do you get my post to apear in your response? David
turbo conversion
Experienced MS/Extra'er
 
Posts: 357
Joined: Thu Aug 19, 2010 6:22 pm

Re: 1.04 to 1.19 question

Postby kjones6039 » Sat Dec 24, 2011 7:58 pm

turbo conversion wrote:Thank you Ken, that is what I will do. Also, how do you get my post to apear in your response? David


By clicking the "QUOTE" button at the top right of your post.

Ken
383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.3.1 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
User avatar
kjones6039
Super MS/Extra'er
 
Posts: 985
Joined: Sat Jul 22, 2006 8:02 pm
Location: Eureka, NV USA


Return to Tuner Studio

Who is online

Users browsing this forum: No registered users and 3 guests