I have a question about this output/LED.
When I power op the MS3 on Jimstim, the FIDL LED is flashing rather rapidly, then after a few seconds, it turns solid (or flashing faster than our eyes can see)
What is that feature?
I tried to set the idle control to ON/OFF 60*C and to Fidle output. No change in operation then I turn the CLT pot.
If the Fidle is used elsewhere in the settings i should have seen an error message trying to use the output to another feature?
Fidle ouput question
Moderators: jsmcortina, muythaibxr
Fidle ouput question
-MS3X, (V3 PCB) 1.2 RC 1 firmware. Controlling a light modified Audi 1.8TQ AEB 20v engine with Holset HE221W turbo, 299.4 HP and 400Nm at the hubs in Dynapack.