simulating LC-1 output. AFR = 2V + 9
P.S. I tried custom controller and set 1V = 11 AFR, 4V= 17 AFR. Same result.
I took some datalogs for about 1minute at idle to check the AFR was 13.5, gauge on dash showed 13.5 but TS showed 12.5
Also we did some live tuning (VE analyse Live) and that seemed to tune with regard to the AFR as shown on the gauge in the dash, not the AFR shown in TS.
I was wondering if it takes an ADC and applies a conversion to show as AFR and I was thinking that might have a problem.
Users browsing this forum: EnricGuardiaSinfreu and 2 guests