Launch Problem on 3.2.1 (SOLVED)

[Paul_VR6]

I can't get launch to work on 3.2.1

Circuit verified by using another processor using 3.1.1 - works
Loading known good msq on 3.2.1 - no luck
Loading 'problem' 3.2.1 msq on 3.1.1 - works
Verified circuit using scope
Base msq from 3.2.1 and only updated launch pin to JS4 - no luck

I am out of time for the moment but the next step will be a 3.2.1msq on 3.1.1 and see what happens.

Datalog and various msq's attached.

[Paul_VR6]

Ran out of attachments, log attached.

[Paul_VR6]

Using both 3.2.1 msq's on 3.1.1 firmware shows launch working.

[jsmcortina]

It works ok on a Microsquirt module using the "FLEX" input.

James

[jsmcortina]

Tested on an MS2, works ok?
When I ground DIP40-pin30 (JS4) the launch in is active and the timing retards to 1BTDC. (With other conditions met.)

James

[Paul_VR6]

Even using the dated msq? Its almost like there is a pin conflict as I can see it go low on the scope.

[jsmcortina]

Even using the dated msq? Its almost like there is a pin conflict as I can see it go low on the scope.

I concurr. That particular MSQ is triggering a problem in the code.
Entering those launch settings from scratch works ok. Using PE0/JS7 with that MSQ instead works too.

James

[jsmcortina]

Far simpler than all that...

User level needs to be set to "Advanced"

James

[Paul_VR6]

Set to Advanced, power cycled and it works.

Any rhyme or reason for that happening?

Thanks for the help James! Feel free to update the title to *SOLVED*