Tunerstudio shows fullsync about every third start and I wonder why.
Perhaps there is like a problem with just the TS indication. TS never shows half-sync just only not goes green on the full-sync gauge.
I've runing on 1.06 and are now trying with 1.1 pre20 but with the same behavior. I've 2 cars with this problem.
Setup is 4cyl, vr36-1, hall-gt1, ls2-cop
Half and full indication
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 38
- Joined: Wed May 19, 2004 12:13 pm
- Location: Sweden
Half and full indication
Bmw 2002, 4cyl-turbo, itb, ms3x, seq cop ls2, 36-1, high ohm, lc-1, 401whp
-
- Helpful MS/Extra'er
- Posts: 38
- Joined: Wed May 19, 2004 12:13 pm
- Location: Sweden
Re: Half and full indication
composite log for half vs full
Bmw 2002, 4cyl-turbo, itb, ms3x, seq cop ls2, 36-1, high ohm, lc-1, 401whp
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Half and full indication
Not showing green full sync means that it is only half-synced.chellquist wrote:TS never shows half-sync just only not goes green on the full-sync gauge.
With your wheel mode it means that it hasn't yet received the cam signal and will be running wasted-COP ignition.
I'm not able to replicate the symptoms you report on the bench.
If I unplug the cam wire on the stim and increase rpms from zero, it shows as half-sync. When I plug the cam wire in it immediately changes to full sync.
Your comp logs appear to show a valid cam signal.
EDIT: You'll be able to tell if you are in wasted-COP by hooking up a strobe to one of your ignition leads. The rpm will show double.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".