jjmclure wrote:This might be a stupid question - I have ordered a wrist anti static strap but I was wondering, would wearing rubber gloves inhibit static when assembling an ms board?
IMO, the wrist strap is pretty much a must. I doubt that rubber gloves are necessary but would keep body oils etc. from contaminating the board contacts.
The big plus would be no finger prints! (they will never trace the board back to you!)
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.3.3 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7