R33 for V3.0 board MS2

All questions about MS2/Microsquirt/Microsquirt module. See also MS2/Extra manuals

Moderators: jsmcortina, muythaibxr

R33 for V3.0 board MS2

Postby efims » Thu Jun 14, 2012 5:52 am

From the assembly manual

"Even if you have installed the PWM flyback damping circuit, you should install the standard flyback circuit as well (step #70).

70. To install the standard flyback circuit:

Install R18 and R33 {270QBK-ND, red-violet-brown}. These are located below R38 and Q1 on the heat sink."

I ran out of 270 Ohm...but I have a few 330 Ohm....can I use 330 Ohm for R33?

Thanks in advance
efims
Helpful MS/Extra'er
 
Posts: 63
Joined: Sun Oct 30, 2011 8:59 am

Re: R33 for V3.0 board MS2

Postby damon308 » Fri Jun 15, 2012 4:04 am

Hi, Yes that should be fine, Regards DM
damon308
Experienced MS/Extra'er
 
Posts: 285
Joined: Tue Nov 17, 2009 7:36 am


Return to MS2/Extra, MS2, Microsquirt and Microsquirt module support

Who is online

Users browsing this forum: Bing [Bot], Ledfut, yellowlt1ta and 2 guests