crank position sensor

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
Cfritz2012
MS/Extra Newbie
Posts: 5
Joined: Wed Feb 08, 2017 6:33 pm

crank position sensor

Post by Cfritz2012 »

ª-Jetski-Jet-Ski-Yamaha-66e-800cc-Flywheel.jpg
I am working on a project and i need some help figuring out how to set up the crank position sensor. its a 2 stroke 2 cylinder engine with a hall sensor type cps. what confuses me is that it has 2 teeth. one short one and right after it it has a long tooth the goes about 1/8 around the fly wheel. i would guess this is a twin trigger?
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: crank position sensor

Post by Matt Cramer »

Currently, this pattern is not supported.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Cfritz2012
MS/Extra Newbie
Posts: 5
Joined: Wed Feb 08, 2017 6:33 pm

Re: crank position sensor

Post by Cfritz2012 »

Well that really puts a damper on my plans...
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: crank position sensor

Post by Matt Cramer »

Cfritz2012 wrote:Well that really puts a damper on my plans...
Well, you could take that damper and see if one of these fits...

https://www.diyautotune.com/support/tec ... k-trigger/
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Cfritz2012
MS/Extra Newbie
Posts: 5
Joined: Wed Feb 08, 2017 6:33 pm

Re: crank position sensor

Post by Cfritz2012 »

I have a sensor and a wheel from yall. I just need to find out where to mount it. This specific engine doesn't have to many options for mounting.
Post Reply