VEAL and dual table option

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
lutorm
Helpful MS/Extra'er
Posts: 146
Joined: Sat Apr 11, 2015 2:53 pm
Location: The island of Hawaii

VEAL and dual table option

Post by lutorm »

Hey all,

I have a Microsquirt running MS2 3.4 with 2 widebands and the "dual table" and "dual wideband" options. Wideband 1 is hooked up to the cylinders using injector channel 1 and wideband 2 with injector channel 2. When running VEAL in TS, I can choose whether I want to tune VE table 1 or 2, but in both cases the little dash on the side shows lambda 1. How do I get it to use lambda 2 with VE table 2? (Or does it automatically do this because I have the dual wideband option enabled? If so, it would still be nice to have it show the lambda it uses for tuning.)

Thanks,

/Patrik
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: VEAL and dual table option

Post by LT401Vette »

It should do that automatically with most firmwares.

What version firmware are you using?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
lutorm
Helpful MS/Extra'er
Posts: 146
Joined: Sat Apr 11, 2015 2:53 pm
Location: The island of Hawaii

Re: VEAL and dual table option

Post by lutorm »

LT401Vette wrote:It should do that automatically with most firmwares.

What version firmware are you using?
3.4.0

Like I said, it might be using lambda2 for VE table 2, all I know is that the gauge still says lambda1.
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: VEAL and dual table option

Post by LT401Vette »

The gauges on the left by default are the same for all of them.

However, if you notice the graph on the bottome should have the channels that are being used, so that should be showing lambda2 on table 2.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
lutorm
Helpful MS/Extra'er
Posts: 146
Joined: Sat Apr 11, 2015 2:53 pm
Location: The island of Hawaii

Re: VEAL and dual table option

Post by lutorm »

LT401Vette wrote:The gauges on the left by default are the same for all of them.

However, if you notice the graph on the bottome should have the channels that are being used, so that should be showing lambda2 on table 2.
Ah-ha. Indeed it does. Thanks!
Post Reply