I'm setting up a tach output to drive my existing tach using JS0 jumpered to IAC1. Went into Basic Load Settings/Tacho Output
and assigned IAC1 as the output. Do I still need to go to ON/OFF Outputs and enable IAC1 or is it connected??
Thanks.
Tach settings
Moderator: LT401Vette
Re: Tach settings
In the tach settings only, if you enable it in that and the on/off ports you will get a config error as you are trying to use the same output twice
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
Re: Tach settings
Thanks.