Tach settings

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
107merc
Experienced MS/Extra'er
Posts: 167
Joined: Fri Mar 28, 2014 10:35 am

Tach settings

Post by 107merc »

I'm setting up a tach output to drive my existing tach using JS0 jumpered to IAC1. Went into Basic Load Settings/Tacho Output
and assigned IAC1 as the output. Do I still need to go to ON/OFF Outputs and enable IAC1 or is it connected??
Thanks.
grom_e30
Super MS/Extra'er
Posts: 4451
Joined: Thu Mar 08, 2012 12:44 pm
Location: UK

Re: Tach settings

Post by grom_e30 »

In the tach settings only, if you enable it in that and the on/off ports you will get a config error as you are trying to use the same output twice
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
107merc
Experienced MS/Extra'er
Posts: 167
Joined: Fri Mar 28, 2014 10:35 am

Re: Tach settings

Post by 107merc »

Thanks.
Post Reply