DOUBLE DISPLAY WITH MS3?

[romano]

Hello,

I hope this topic is in the right section...

The objective: connect 2 tablet connected to ms3 ecu.
one for dashboard with all important data and the other one for others sensors but located on central panel.

I've tried MS3 serial port converted to usb (FTDI) plugged to a tablet OR a w10 laptop AND MS3 usb port plugged to a tablet.
I've tried ShadowDash, Racedash, MS Droid and finally TStudio (on laptop)
I have some erratic comportment...

I need your experience:
is it possible to use 2 MS3 data output in same time?
Could it be a solution if I switch to bluetooth adapter (instead of serial/usb converter)?

Thanks for your feedback.
Is it due to uncompatibility of something ?


R.

[MS2tester]

as far as i understand it megasquirt can only use 1 port to communicate with the standard interface
i have been looking into the same thing
possible solutions are
raspberry 4 with dual display capability
raspberry using tunerstudio connected to an other megasquirt ( MS2,microsquirt,..) which connect to your MS3 over the CAN bus
this would mean a raspberry,tunerstudio, megasquirt combination for each display
i have been trying to use a tinyox for this but support is still limited
http://forum.jbperf.com/viewtopic.php?f=9&t=1797

[KostanayKorch]

https://youtu.be/_CXSv346tkU
https://youtu.be/vmUZtzEtLDU
https://youtu.be/maz9Xyr5RWU
It 's actually easy . You need a tablet for Windows, a tuner studio and as many screens as you want. Windows supports many screens and you need to assign a master and a slave in the settings and the tuner studio stretches to all screens. You can put your own sensors and indicators on each screen as in this video