I have switched much of my IO board stuff to 29 bit. it all seems to be working properly, and does coexist fine with some 11 bit stuff that remains.
But it seems to be polling very slowly. Is this typical? How is the polling controlled. and how can I measure it.
I have 29 bit EGO, GEAR, ADC's, CAN-IN, CAN-OUT, and CAN-PWM-OUT enabled, and seemingly working.
attached is a shot of the basic settings. and the msq (bench hackery)
Bob
29 bit polling rate
Moderators: jsmcortina, muythaibxr
29 bit polling rate
You do not have the required permissions to view the files attached to this post.
Re: 29 bit polling rate
update, I think the issue is on my end.
thanks
thanks