Hello I’m a newbie here but a software/firmware guy with 40+ yrs experience. Retired now with a lot of extra time . Where do you get the source for ms2? What is the contribution process? I am working on an engine with headers and dual wide band, would like to monitor and react to both channels. Let me
Know,
thanks!
How to get started with ms2 firmware
Moderators: jsmcortina, muythaibxr
Re: How to get started with ms2 firmware
Find the download tab at the top of the forum page. I think 3.4.2 was the last release with the source code included. There is a tool chain that needs to be downloaded which is also available.
I use Cygwin(32 bit) within windows to compile the source.
Ryan
I use Cygwin(32 bit) within windows to compile the source.
Ryan
306 SBFord, Torquer II EFI intake, 60 lbs injectors, 8 LS2 coils, VS Racing 7668 turbo, 4R70W, MS3x fw1.4 w/built in trans controller.
Re: How to get started with ms2 firmware
Hello I can find references to tools but can not seem to locate them. Where are they located? Thanks
-
- Site Admin
- Posts: 39622
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: How to get started with ms2 firmware
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".