MS3 1.6.0 Knock Debug (per-cylinder knock retard) blocks more inputs than needed

[ShirtUser]

MS3 Pro Ultimate

From the 1.6.0 changelog:

Knock
Allow knock_conf_debug on MS3Pro if num_cyl is small enough.


However, when setting "DEBUG Data" to "On" under "Knock Sensor Settings" and then power cycling, the following error is presented:

"Generic ADC Inputs cannot be used when knock DEBUG data is enabled"

Even though I only have 8 cylinders in the tune, if anything is selected for Analog inputs 12 or below, the error comes up. Even if "CAN ADCXX" or "Internal MAP Sensor" is selected.

I get that it will overwrite the sensor inputs for each cylinder that it has knock retard data for. But, since it's only an 8 cylinder, shouldn't it only overwrite 01 through 08, leaving 09 through 12 alone?

Either way, the error message should be updated to indicate that "Nothing can be selected in the Generic Sensor Inputs 01 through XX" instead of saying "Generic ADC Inputs cannot be used".