Pull-Up configuration for multiple hall sensors
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 1
- Joined: Thu Mar 28, 2024 2:29 am
Pull-Up configuration for multiple hall sensors
I possess three hall sensors requiring pull-ups for the crank and two cams. Can I utilize a single pull-up connected to +12V using, for example, a 1k resistor to supply all of them? Alternatively, should I opt for individual pull-ups for each sensor?
-
- Site Admin
- Posts: 39622
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Pull-Up configuration for multiple hall sensors
You must use one resistor each.
Otherwise you would be shorting all of the tach signals together, which would stop them from working.
James
Otherwise you would be shorting all of the tach signals together, which would stop them from working.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".