<<Previous page ˆˆTop pageˆˆ This page Next page>> Click here for all of the manuals
MS2V3.0 Hardware Guide 5.3.1.3 Logic spark outputs - FET driver method This circuit is suitable for driving LS1 type coils and many other logic coils including VW COPs with a low input With this wiring the Spark output must be set to "Going High". Pros: Can drive most logic coils including low resistance VAG COPs. Coils do not receive a spurious signal pulse at power on. Uses standard "Going High" setting. Cons: Can be more difficult to install. Requires a few more additional components. Build the following circuit(s) in the proto area or on prototype board. Parts required for two channels: TC4427AEPA 2x 15R 1/8W resistors (c) 2014 James Murray 2015-05-05 Page 76/200 | |||