Is there any way to use a static center point instead of 50%?
I would like to compare my EGT channels to a static number instead of the average value
Thanks
Datalog Field View
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Datalog Field View
Nope.
Let me see if I have the need straight.... You want to be able to set the horizontal dashed line to a specific value so you can see where the other EGT's are relative to one?
Let me see if I have the need straight.... You want to be able to set the horizontal dashed line to a specific value so you can see where the other EGT's are relative to one?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: Datalog Field View
Can't you get the same effect by setting fixed limits?
For example, set lower limit at 500, upper at 1000, then the center line would always be at 750.
For example, set lower limit at 500, upper at 1000, then the center line would always be at 750.
Eric Law
1990 Audi 80 quattro with AAN turbo engine: happily running on MS3+MS3X
2012 Audi A4 quattro, desperately in need of tweaking
Be alert! America needs more lerts.
1990 Audi 80 quattro with AAN turbo engine: happily running on MS3+MS3X
2012 Audi A4 quattro, desperately in need of tweaking
Be alert! America needs more lerts.
-
- Master MS/Extra'er
- Posts: 409
- Joined: Sun Jan 30, 2005 11:13 pm
- Location: Monroe, Wa.
- Contact:
Re: Datalog Field View
I remoted into my desktop and that looks like it's exactly what i was looking for.elaw wrote:Can't you get the same effect by setting fixed limits?
For example, set lower limit at 500, upper at 1000, then the center line would always be at 750.
Thank you!
Phil, yes that's basically what i want to make it easier to trim other cylinders.