Folks -- 4.0.20 megalogviewer
In my tune file, I'm using ITB load for my VE table, and speed density for my spark table
I noticed when playing a log file, the blue tracing dots do not reflect the two modes.
Took me a minute to figure out why my recorded spark advance numbers didn't match the trace!
VE/SparkMap Trace incorrect when different modes
Moderator: LT401Vette
VE/SparkMap Trace incorrect when different modes
VW Turbo Buggy 2276cc MS3X sequential
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: VE/SparkMap Trace incorrect when different modes
You can right click on the Y Axis of the advanceTable and select "Set Y Axis Over-ride"
set it to the field that properly represents your Spark Load.
set it to the field that properly represents your Spark Load.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html