http://www.msextra.com/viewtopic.php?f= ... ead#unread
And I can get it to work in MT on my desktop, but not TS on my desktop (with the example projects) I wanted to try it here before I tried it on my real project on my tuning laptop, which only has TSOK,
I added some debug code to study this issue and observe 8 tach pulses in before the code starts to squirt fuel. That's four revolutions on a 4 pot. I now appreciate the problem!!
While I am looking into the code to optimise it, one patch that can be applied is to tweak the ini as follows
In your megasquirt-ii.ini file find and amend the following lines.
e.g. C:\Program Files\Megasquirt\Megatune2.25\MtCfg\megasquirt-ii.ini
approx line 118
no_skip_pulses = scalar, U08, 1, "", 1.00000, 0.00000, 1.00, 255.00, 0 ; * ( 1 byte)
approx line 1241
field = "Skip Pulses", no_skip_pulses (remove other field)
Then re-open Megatune and find the "skip pulses" on the "tach input/ignition settings" menu. Set this to zero or one.
Please report if this helps.
James
When I mod the .ini, the field becomes "available" in TS, but when I go to burn or close the dialog it says no_skip_pulses must be>=3.