Hi,
if there are multiple controllers connected to TS with CAN passthrough, if two or more controllers have differences between the offline and online tune, then the differences are shown for the first controller, and before you have any time to react, the window closes and the differences for the second controller are show, if there's a third controller with differences then the second window is closed and the third one pops up.
So for 3 controllers, I have to deal with the 3rd controller first, then reload the project, deal with the second controller, then finally reload the project once more and deal with the main controller.
Maybe all these could be put into 3 (or N) separate tabs in the difference report window? So a tab for each controller.
Difference report with multiple controllers
Moderator: LT401Vette
Difference report with multiple controllers
The man behind MS Labs
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Difference report with multiple controllers
Does sound problematic. I'll have to have a look.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html