Hello,
Just a quick message to let people know that flashing a firmware over Wifi work well.
I just flash a Microsquirt Module. It was the first flash of the module that normally ask for a power-off when using command line MS2loader.
Using TunerStudio MS, it don't ask for a power-off and everything work well.
I just notice that when one use TunerStudio MS firmware update utility, at the moment when TS really send the firmware, the "Next" button is available. I don't try to click it until the entire firmware was loaded so I don't know what can happen if this button is "clicked" when TS send firmware. To be honest, I would prefer this button to appear ONLY when firmware is entirely send to the ECU.
Best regards,
Manu
Flash Firmware using Wifi and TunerStudio MS
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Flash Firmware using Wifi and TunerStudio MS
Yes, I have tested over wifi. Always seems to work, but takes for ever...
I am still much more comfortable with a real cable.
I am still much more comfortable with a real cable.
The Next Button should not work until it is done. It should pop up a message if you try.I just notice that when one use TunerStudio MS firmware update utility, at the moment when TS really send the firmware, the "Next" button is available. I don't try to click it until the entire firmware was loaded so I don't know what can happen if this button is "clicked" when TS send firmware. To be honest, I would prefer this button to appear ONLY when firmware is entirely send to the ECU.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Master MS/Extra'er
- Posts: 723
- Joined: Mon Feb 15, 2010 4:57 am
- Location: Alès - France
- Contact:
Re: Flash Firmware using Wifi and TunerStudio MS
It may depend of the adapter. I didn't notice any latency or "long" flash with mine.LT401Vette wrote:Yes, I have tested over wifi. Always seems to work, but takes for ever...
Glad to know. Would it be better to hide it until flash is complete ?LT401Vette wrote:The Next Button should not work until it is done. It should pop up a message if you try.