Distributor with 1 pulse per Ignition Event (spark)
Specific Connections and Setting

Please Note:
If you have any suggestions or setups that I can put in here to help others please get in touch and I will include it in the list below. Philip.Ringwood(at)ntlworld.com

These links are for distributor specific connection schematics and TunerStudio settings. For a detailed discussion see here

Caution:
These connection diagrams for coil outputs are matched to the TunerStudio Settings. Make sure the correct settings for Spark Output Inverted are matched to the connections. Failure to do so may damage the coil and coil driver.

 

 

MS Connections
TunerStudio Settings*

Distributor Points, Fuel only

MS v2.2    MS v3.0
MS v2.2, MS v3.0

Distributor Points with spark
MS v2.2    MS v3.0
MS v2.2, MS v3.0

After Market Electronic Ignition

MS v2.2    MS v3.0
MS v2.2, MS v3.0

Crane XR700 (Optical Trigger)

MS v2.2 LED17 spark
MS v2.2   FIDL spark

MS v3.0

MS v2.2 LED17 spark
MS v2.2   FIDL spark

MS v3.0
Malory Unilite (optical trigger)
MS v2.2    MS v3.0
MS v2.2, MS v3.0
Nissan KA24E and a KA24DE
(optical trigger)
MS v2.2    MS v3.0
MS v2.2, MS v3.0
Toyota VAST distributor (~1985-1993)
(VR conditioned trigger)

Overview
MS v2.2    MS v3.0
MS v2.2, MS v3.0
Setting up the distributor
(Next Cylinder mode)
Setup/Install
Settings

*All of the above TunerStudio settings are for Next Cylinder Mode. See below for an explanation of Next/This cylinder mode

Advanced Topics: This/Next Cylinder mode
If you have a question, comment, or suggestions, please e-mail Phil or James or Ken or post it on the MS-Extra forum.
© 2004 - 2006, Bruce Bowling and Al Grippo. All rights reserved.